• Judland's Commodore Blog

  • by judland

These are the ramblings of a happy Commodore computer user since 1983. I cover topics on both the C64 and C128, reviewing my favorite games and applications, as well as share some of my favorite memories from the 8-bit era. If you'd like to read more, you can visit my blog at: https://www.my64.in.nf -or- https://www.my128.in.nf

Oct
30

A failing 1541

After sitting in cold/hot storage for the better part of four years, I finally got around to getting out my original 1541 floppy disk drive and giving it a test drive. Right from the get-go, however, the drive didn't sound very good, nor did it appear to work properly. Oh boy.

A repost from my Commodore blog, here...


Upon start-up, the spinning of the center spindle sounded terrible, making a “wysh, wysh, wysh” sound. I put a test floppy into the drive and tried to read the directory, which worked, but loading a program resulted in disk errors. Along with disk errors, there was a high pitched sound which seemed to coincide with the movement of the read/write head assembly. I thought that the less than perfect storage conditions had done in my floppy drive. But, I decided to proceed with trying to fix what I could to see if I could get my old drive working once again.

I took the top cover off and inspected the circuit board inside. This particular 1541 is the original long board model with ALPS mechanics. Everything looked fine and I was surprised at how clean the inside of the drive was. I then removed the circuit board and focused my attention on the head assembly and center spindle. It all looked okay to me, but the movement of the head assembly didn't feel very smooth. However, the stepper motor and drive belt looked good.

I took some light oil (the same oil I use to lubricate my air compressor tools) and applied a small amount to the two head assembly rails, as well as forced a few drops under the center spindle. And, before securing the circuit board back into place and closing up the case, I cleaned off the read/write head with some alcohol.

1541 Internals

I had no idea if this would be enough to get my disk drive running properly again, but I thought I'd give it another try.

When I powered up the drive, I heard the same wyshing sound of the center spindle, but this time it was much quieter. I inserted a disk and tried to read a directory. Again, I heard the high pitched sound I heard earlier, but it only lasted for a few seconds. I tried loading a program off of the disk and this time, it worked!

I followed up by giving the head assembly some exercise by trying to format a new disk. As the oil got distributed by the moving mechanics, all of the odd noises faded away and the drive seemed to be working perfectly, once again.

From what I've read about the differences between each model of the 1541 disk drives, the ALPS mechanics are known to be the noisy-est. However, as it is right now, my old 1541 is even quieter than my 1541-IIs. I guess it's time for me to crack those open and give them a shot of oil, as well.

I'm pleasantly surprised that all I needed to do was apply a bit of lubrication to get my old 1541 working properly again. But, then again, the ALPS mechanics are considered as being pretty reliable. I guess the general opinion is right, in this regard. What a marvel of electronic engineering!

Hopefully this disk drive will now provide me with reliable service for many more years to come.

Leave a Comment

You must be signed-in to post comments.

Responses